It will receive its IP address from the DHCP server via the wireless link to the local UBB radio.įor each UBB radio, go to the appropriate mounting instructions: Pole Mounting or “Wall Mounting”. Remote UBB radio (bridged LAN) This Gigabit Ethernet port is used to connect the power and should be connected to the LAN. Local UBB radio (source LAN) This Gigabit Ethernet port is used to connect the power and should be connected to the LAN and DHCP server. If a link is lost due to configuration changes, you can reset both UBB radios to re-establish the link. After a few seconds, the LED will turn off, and the device will automatically reboot. Press and hold the Reset button for about 10 seconds until the LED starts flashing and then becomes solidly lit. The device should be running after bootup is complete. Note: If the other bridge device is within range and the UBB LED is green and red, we recommend moving the UBB device up or down until the LED is green. When the UBB devices are properly aligned, the LED will turn green. In the Manage Device section of the UniFi Network Application, you can enable the Alignment Tool.
Note: If the other bridge device is within range and the UBB LED is red, we recommend moving the UBB device up or down to enhance the signal strength. When the 60 GHz link is re-established, the LED will turn blue or the custom color you selected in the UniFi Network Application. If the UBB fails over to 5 GHz, the LED will remain red. The 60 GHz link cannot be established or has dropped due to bad weather. The software will also display the location of the device on the map. When you click Locate in the UniFi Network Application, the LED will flash blue. Successfully integrated into a network and working properly.
This usually indicates that a process such as a firmware upgrade is taking place. The ETH-SP-G2 will absorb power surges and safely discharge them into the ground.įactory defaults, waiting for integration.ĭevice is busy do not touch or unplug it.
We recommend that you use two Ethernet Surge Protectors, model ETH-SP-G2, one near the device and the other at the entry point to the building. Surge protection should be used for all outdoor installations.For more details, visit ui.com/toughcable We recommend that you protect your networks from harmful outdoor environments and destructive ESD events with industrial-grade, shielded Ethernet cable from Ubiquiti. Shielded Category 5 (or above) cabling with drain wire should be used for all wired Ethernet connections and should be grounded through the AC ground of the PoE.The device needs to have clear line of sight to the sky for proper GPS operation.Wall-mounting: wall fastener (not included).Pole-mounting: 8 mm socket wrench or screwdriver.
Linux, Mac OS X, or Microsoft Windows 7/8/10.UniFi Cloud Key (1.0.5 or newer) or UniFi Dream Machine (1.0.1 or newer).